Rc Car ignition killer

Designed on request, rc nitro car ignition killer.Will kill the ignition of a rc-nitro car by hand trough the 3e rc-channel or if the voltage drops below a programmed voltage.
Schema / source / handleiding etc (rev.1)
-Schematic and pcb designed with Eagle 4.15
-Software created with Bascom-avr

Revison 2: Some receivers are working on an higher voltage then the default 5V. The BEC systems are direct connected to the battery so the voltage can rise up to 7V. Added very low drop 5V voltage regulator and extra resistor in the servo in line to limit the zener current.

 

3D Design version 1
Finished pcb version 1
3D Design version 2
Finished pvb version 2
PlayPause
previous arrow
next arrow
 
3D Design version 1
Finished pcb version 1
3D Design version 2
Finished pvb version 2
previous arrow
next arrow